la fotoresistenza e arduino

Questo in basso è il codice per far funzionare lo schema(si può anche fare il copia ed incolla)

/* Photocell simple testing sketch. 
 
Connect one end of the photocell to 5V, the other end to Analog 0.
Then connect one end of a 10K resistor from Analog 0 to ground 
Connect LED from pin 11 through a resistor to ground 
For more information see www.ladyada.net/learn/sensors/cds.html */
 
int photocellPin = 0;     // the cell and 10K pulldown are connected to a0
int photocellReading;     // the analog reading from the sensor divider
int LEDpin = 11;          // connect Red LED to pin 11 (PWM pin)
int LEDbrightness;        // 
void setup(void) {
  // We'll send debugging information via the Serial monitor
  Serial.begin(9600);   
}
 
void loop(void) {
  photocellReading = analogRead(photocellPin);  
 
  Serial.print("Analog reading = ");
  Serial.println(photocellReading);     // the raw analog reading
 
  // LED gets brighter the darker it is at the sensor
  // that means we have to -invert- the reading from 0-1023 back to 1023-0
  photocellReading = 1023 - photocellReading;
  //now we have to map 0-1023 to 0-255 since thats the range analogWrite uses
  LEDbrightness = map(photocellReading, 0, 1023, 0, 255);
  analogWrite(LEDpin, LEDbrightness);
 
  delay(100);
}